Dying Light the Beast Power Gambit Pumps

Dying Light The Beast – How To Activate The Power Gambit Pumps

Dying Light The Beast

Activating the Power Gambit Pumps is an objective during the sixth main quest in Dying Light the Beast. Kyle must travel to the Castor Woods power station and fix it.

Let’s see how you can complete the mission!

How to Fix the Power Gambit Pumps in Dying Light the Beast

Kyle’s task is to assist the Old Town survivors by activating the power grid. Make sure to be ready for combat, as there’s a lot of fighting in this mission. Follow the quest marker and reach the power station. Clear the enemies in the area.

Get to the Foreman

Notice the quest marker pointing to the building. You must climb it to reach the foreman.

Foreman

Go to the main entrance and grab onto the ledge just before the building’s corner. Make your way up and follow the ledge around the corner. Use the ledge between the windows to go up. Go right, past the ivy, following the ledge.

Foreman Climb

Continue and reach the other side of the building. Jump up using the ledges and get to the roof. Go towards the quest marker, leading to an area covered in ivy. You can drop down here on the ledge below and enter the building through the window. Make sure to kick the ladder before going inside. Find the foreman, Largo, in his office and talk to him to start the next task.

How to Enter the Power Plant

Go outside and notice the other building. You need to climb it in order to reach the power station.

Dying Light The Beast Power Gambit Power Plant

Grab onto the ledge and go up using the pipe. Continue on the ledge to the right and follow it until you are under the last window. Drop down four times and keep going right, using the vent shaft. Climb up, using the small ledges between the windows, and advance towards the quest marker.

Dying Light The Beast Power Gambit Power Plant Climb

Slide down along the pipe until you are on the same level as the air conditioning unit. Go right and use the small ledges between the windows. Jump and cling to the air conditioning unit. From there, you can jump and reach the balcony on the right. Look up and notice the quest marker on the open window above. Grab onto the ledge and reach the pipe.

Dying Light The Beast Power Gambit Power Plant Climb 2

Now, you need to jump and grab the ledge under the ivy. Follow the ledge to the next pipe and use it to go up and reach the open window to get inside. The next part requires you to drain the water. Follow the stream of bubbles and the quest will update with the location of the valves. Close them and move on to the next objective, powering the pumps.

How to Activate the Power Gambit Pumps in Dying Light the Beast

Follow the quest marker and turn on the generator.

Dying Light The Beast Power Gambit Pumps

Take the cable from the nearby electrical box. Notice the blocked vent. Go to the opposite side and move the cabinet blocking the vent.

Dying Light The Beast Power Gambit Pumps Move Cabinet

Take the cable, enter the vent, and plug it into the machine to power the pumps.

Check out more Dying Light the Beast guides!

Dying Light The Beast Beavers – Castor Woods Beavers Locations
Dying Light The Beast – How To Complete The Hydro Puzzle Side Quest

Leave a Reply

Your email address will not be published. Required fields are marked *